Router Rip; Router Vrrp; Session - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands

router rip

User level: read-write, admin.
You can only access this command in configure mode.
Type configure at the command prompt to enter interface mode.
Use the router rip command to configure the Routing Information Protocol
(RIP). Use the no router rip command to disable RIP.
The default state is disabled.
The syntax for this command is:
[no] router rip
Example:
To enable the RIP protocol:
Router-1(configure)# router rip
Done!

router vrrp

User level: read-write, admin.
You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode if necessary.
Use the command to enable VRRP routing globally.
Use the no router vrrp command to disable VRRP routing.
The syntax for this command is:
[no] router vrrp
Example:
Router-1(configure)# router vrrp
Done!

session

User level: read-only, read-write, admin.
Displays existing sessions or to opens a session with a specific Supervisor Module in
the chassis.
70 Avaya P460 Reference Guide