Default-Metric; Disable Interface - Avaya P460 Reference Manual

Example:
P460-1# copy tftp SW_imageB c:\imgB.bin 149.49.36.200
Beginning download operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
*********************************************************************
* If you are currently running the P460 Device Manager application, *
* it is recommended to exit from it before performing configuration *
* download operations.
*********************************************************************

default-metric

User level: read-write, admin.
You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode if
necessary.
Use the default metric command to set the interface RIP route metric.
Use the no default metric command to restore the default value.
The default metric is 1.
The syntax for this command is:
[no] default-metric <number>
number
Example:
Router-1(configure-if:marketing) # default metric 10
Done!

disable interface

User level: read-write, admin.
Use the disable interface command to disables the inband or outband
interface.
Avaya P460 Reference Guide
The interface RIP route metric value. The range is 0 to 15.
Chapter 2 Avaya P460 CLI Commands
*
27