Chapter 6: Avaya C360 Default Settings; Configuring The Switch; C360 Default Settings - Avaya C360 Installation And Configuration Manual

Chapter 6: Avaya C360 Default Settings

This section describes the procedures for the first-time configuration of the C360. The factory
defaults are set out in detail in the tables included in this chapter.

Configuring the Switch

You may configure the C360 using the text-based Command Line Interface (CLI), the built-in
C360 Device Manager or Avaya Integrated Management.
For instructions on the CLI, see the Reference Guide for the Avaya C360 Converged Stackable
Switch, 10-300506.
For instructions on the use of the graphical user interfaces, refer to the C360 Device Manager
User Guide on the Avaya C360 Documentation and Utilities CD.

C360 Default Settings

The default settings for the C360 switch and its ports are determined by the C360 firmware.
These default settings are subject to change in newer versions of the C360 firmware. See the
C360 Release Notes for the most up-to-date settings.
Table 21: Default Switch Settings 1 of 2
Function
IP address
Subnet Mask
Default gateway
Management VLAN ID
Spanning tree
Bridge priority for Spanning Tree
Spanning tree version
Default Setting
149.49.32.134
255.255.255.0
0.0.0.0
1
Enabled
32768
Common spanning
tree
1 of 2
Issue 1 July 2006 91