Avaya P333R Default Settings - Avaya P333R-LB Quick Start Installation Manual

Prepare for Configuration
5. Press Enter to save the destination and gateway IP addresses.

Avaya P333R Default Settings

If you wish to change the default parameters shown and configure the mandatory parameters,
we recommend that you use the Command Line Interface (CLI).
For further information, please refer to Chapter 6 of the Avaya P333R-LB User's Guide.
The default settings for the Avaya P333R-LB switch and its ports are determined by the Avaya
P333R-LB firmware. These default settings are subject to change in newer versions of the
Avaya P333R-LB firmware. See the P333R-LB Release Notes for the most up-to-date settings.
28 Quick Start for Hardware Installation: P333R-LB Stackable Switch
Table 6: Default Switch Settings
Function
IP address
BootP mode
Subnet Mask
Default gateway
Management PC SLIP IP Address
Management VLAN ID
Spanning tree
TFTP Mode
TFTP Server
TFTP File Name
SNMPv1 communities:
Read-only
Read-write
Trap SNMP
SNMP authentication trap
CLI timeout
User Name/Password
Default Setting
149.49.32.134
Never
255.255.255.0
0.0.0.0
192.168.10.2
1
Enabled
Limited
0.0.0.0
viisa
Public
Public
Public
Disabled
15 Minutes
root/root