Panel And Interface Leds; Interface Cable - 3Com 3C13701 Module Manual

3Com Router 5000 and Router 6000 v2.41
Module Guide

4.9.3 Panel and Interface LEDs

The following figure illustrates an Router 1-Port CE3 FIC panel.
Figure 4-34 Router 1-Port CE3 FIC panel
The following table describes the LEDs on the card panel.
Table 4-20 LEDs on the Router 1-Port CE3 FIC panel
LED
LINK
ACT

4.9.4 Interface Cable

The external interface provided by the Router 1-Port CE3 FIC uses two SMB sockets
respectively for data transmitting (Tx) and data receiving (Rx). The interface transmits
in 75-ohm unbalanced mode and uses a pair of 75-ohm unbalanced coaxial cables to
connect another device.
BNC connector BNC connector BNC connector BNC connector BNC connector
Figure 4-35 E3/T3 cable
Note:
The Router 1-Port CE3 FIC and the Router 1-Port CT3 FIC use the same cable, called
E3/T3 cable in this manual.
The standard equipping package of the Router 1-Port CE3 FIC includes the required
interface cable.
OFF means no link is present; ON means a link is present.
OFF means no data is being transmitted or received on the interface; blinking means
data is being transmitted and/or received.
Chapter 4 Flexible Interface Cards (Router 6000)
Description
4-32
SMB connector SMB connector SMB connector SMB connector SMB connector