3Com 5000/6000 Quick Reference Manual

3C R
OM OUTER
Q R
UICK EFERENCE
Overview
This Command Reference applies to the following Router 5000/6000 models running software version 3.0.
Router 5012 (3C13701)
Router 5232 (3C13751)
Router 5642 (3C13755)
About the Command Line Interface
To use and navigate the command line interface of your unit, please refer to the following points for assistance:
When initially accessing the command line interface, press Enter when prompted. The User View
■
displays. This is indicated by the chevron brackets around the name of the unit at the prompt, for example,
<router5000-xx> (where xx is either EI or SI).
When in the System View menu, square brackets appear around the name of the unit at the
■
[router5000-xx].
You must be in the System View menu to access the configurable CLI commands.
■
Some commands can be entered directly at any prompt from anywhere in the interface.
■
If you enter part of a command followed by a ? (with no space between), the CLI will show you
■
that begin in that way.
The term 'view' may be used interchangeably with the term 'menu'.
■
c
The ommand is placed before the command you wish to undo, for example,
■
undo
<CTRL-A> places the cursor back to the start of the command line.
■
Enter the first few characters of a command and press TAB to enter the full command without
■
entire command (where there is only one command that starts with the entered characters).
Use the Up Arrow key at the prompt to repeat the previous command string.
■
Use the Delete key to delete the character after the cursor; the Backspace key deletes the character
■
When entering physical port numbers, Enter the port number as
■
physical port number.
Copyright © 2006, 2007 3Com Corporation. All rights reserved.
www.3Com.com
Part Number: 10016467 Rev. AA
Published: October 2007
5000/6000 F
G
UIDE
Router 5682 (3C13701)
Router 6040 (3C13840)
Router 6080 (3C13880)
AMILY
undo setauthentication
, where x is the unit
x/0/z
menu for the unit
prompt, for example,
all the commands
password.
having to input the
before the cursor.
number and z is the