Scanning Active Time - Datalogic PowerScan PD9530 Product Reference Manual

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON
state once the state is entered. The range for this setting is from 1 to 255
seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0
3. Go to
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 41. Scanning Active Time Setting Examples
STEP ACTION
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT SCANNING ACTIVE TIME SETTING
Scan Three Characters
From Appendix D,
5
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
= 000, 5 = 005, 20 = 020, etc.
page 74 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
1 Second
001
'0', '0' and '1'
Table 41 for some examples of how to
90 Sec. (1.5 min.) 180 Sec. (3 min.)
090 180
'0', '9' and '0' '1', '8' and '0'
Scanning Features
Appendix D, Key-
255 Seconds (4.25
min.)
255
'2', '5' and '5'
281