The features in this section are valid only for PBT9500 Bluetooth models.
Also reference the Setup section for instructions on
Reader, starting on page
On the Bluetooth system, it is possible to set a (configurable) PIN code to
authenticate/connect Bluetooth devices, and encrypt the data.
The Bluetooth PIN code can be enabled and configured by reading the bar
codes in the following sections.
Follow these steps to set the PIN code for a scanner:
1.
2.
3. Scan the relevant bar code from
See
page 290
for this feature.
Product Reference Guide
PBT9500-ONLY FEATURES
19.
BLUETOOTH SECURITY FEATURES
If you are using a Bluetooth scanner directly connected to a host through a
Bluetooth dongle, verify that the scanner and the Bluetooth driver used by
the dongle share the same PIN code and the same security level. Otherwise
the connection cannot be established.
Enable
Bluetooth Security Mode by scanning the "Enable" bar code
below.
Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
the desired alphanumeric characters from the keypad in
Keypad
to set the PIN code.
in
"References" for more detailed information and examples
Enter/Exit Programming Mode
"Select PIN Code Length"
"Set PIN Code"
Linking the
on page 224.
on page 225, then scan
Appendix D,
223