Source Radio Address Delimiter Character - Datalogic PowerScan PD9530 Product Reference Manual

Enter/Exit Programming Mode

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
$CBTAD
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
218
This feature only applies if
sion"
on page 217 is enabled.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric charac-
ters in
desired character(s). End by scanning the ENTER/EXIT bar
code again.
~
00 = No Delimiter Character
"Source Radio Address Transmis-
Appendix D, Keypad
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
representing your