This and following sections provide programming bar codes to configure
your reader by changing the default settings. For details about additional
methods of programming, see
Configuration Parameters
Once the reader is set up, you can change the default parameters to meet
your application needs. Refer to
initial configuration in order to set the default values and select the interface
for your application.
The following configuration parameters are divided into logical groups,
making it easy to find the desired function based on its reference group.
Interface Configuration:
•
•
•
Parameters common to all interface applications:
•
•
•
Wireless-Only Features
•
•
•
•
•
•
•
Product Reference Guide
Configuration Using Bar Codes
You must first enable your reader to read bar codes in order to use
this section. If you have not done this, go to
page 7
and complete the appropriate procedure.
"RS-232 Only Interface"
"RS-232/USB-Com Interfaces"
"Keyboard Settings"
on page 37
"Data Format"
on page 49 gives options to control the messages sent to
the Host system by selecting parameters to control the message strings
sent to the handheld.
"Reading Parameters"
indicators status functioning such as programming for scanning,
beeper and LED indicators and other universal settings.
"Motion Features"
on page 205 provide the ability to configure motion
settings for the handheld.
Wireless Configuration:
Wireless beeper features
Configuration Updates
Batch Features
Direct Radio Autolink
PBT9500 only features
PM9500 only features
"Configuration Methods" on page
"Standard Defaults"
on page 25
on page 30
on page 63 control various operating modes and
Chapter 3
6.
Setup, starting on
starting on page 309 for
21