Data Matrix Length Control; Data Matrix Set Length 1 - Datalogic PowerScan PD9530 Product Reference Manual

Enter/Exit Programming Mode

Data Matrix Length Control

This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length:
length may be set.
Fixed Length:
DEFAULT
$CDMLC01(CR)
Data Matrix Length Control = Fixed Length

Data Matrix Set Length 1

Specifies one of the bar code lengths for
1 is the minimum label length if in
length if in Fixed Length Mode. Characters can be set from 0001 to 3,116
characters in increments of 0001 (pad with zeroes).
See page 267
$CDML1
Select Data Matrix Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
184
For variable length decoding, a minimum and maximum
For fixed length decoding, two different lengths may be set.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
$CDMLC00(CR)
Data Matrix Length Control = Variable Length
Data Matrix Length
Variable Length Mode, or the first fixed
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
2D Global Features
Control. Length
repre-