Wireless Features; Automatic Configuration Update; Rf Address Stamping - Datalogic PowerScan PD9530 Product Reference Manual

References

Wireless Features

Automatic Configuration Update

When this feature is enabled, the base station and reader will keep their
configurations synchronized. If a reader's configuration is altered by reading
programming labels, this change is automatically transferred and updated in
a linked base station. Likewise, if the base station's configuration is changed
using Aladdin or by host commands, then the reader's configuration will
automatically be updated if this feature is enabled.

RF Address Stamping

Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
Follow these instructions to select the delimiter character:
1. Determine the desired character, then find its hexadecimal equivalent
2. Go to
3. Scan the bar code: SET SOURCE RADIO ADDRESS DELIMITER CHARAC-
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
Table 48. Source Radio Address Delimiter Character Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
288
This feature only applies if
sion"
on page 217 is enabled.
on the ASCII Chart on the inside back cover. A setting of 00 specifies no
delimiter character.
page 218 and scan the ENTER/EXIT PROGRAMMING MODE bar
code to enter Programming Mode.
TER.
pad, that represent the hexadecimal characters which were determined
in the steps above. You will hear a two-beep indication after the last
character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
EXAMPLES
No delimiter
character
'0' and '0'
"Source Radio Address Transmis-
Appendix D, Key-
, (comma) - (dash)
'2' and 'C' '2' and 'D'
PowerScan™ PD9530/PBT9500/PM9500
/ (slash)
'2' AND 'F'