Datalogic PowerScan PD9530 Product Reference Manual page 285

Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
3. Scan a bar code to select the symbology for which you wish to config-
4. Determine the desired character(s) (you may choose up to three) which
5. Turn to the
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 10. Label ID Position Options
Product Reference Guide
page 56 and scan the ENTER/EXIT bar code.
(Enable as suffix) by scanning the appropriate bar code in the section
"Label ID Control" on page 56. Reference Figure 10 for Label ID posi-
tioning options if multiple identification features are enabled.
ure a custom Label ID from the section
1D Symbologies" on page 57.
will represent the Label ID for the selected symbology.
ASCII Chart
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to
on page 323 and scan the bar codes representing the hex characters
determined. For the example given, the characters '3' and 'D' would be
scanned. More examples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Prefix Label ID Aim ID
"Label ID Symbology Selection −
on the inside back cover of this manual and find
Bar Code Data
OR
Data Editing
Keypad, starting
Table 38.
Label ID Suffix
275