P2 Adapter Preparation (Three-Row) - Motorola MVME2603-1121A Installation And Use Manual

MVME761 Transition Module Preparation
1

P2 Adapter Preparation (Three-Row)

1-32
The P2 adapter for the MVME761 transition module routes the
synchronous and asynchronous serial, parallel, and Ethernet
signals to the MVME761. The P2 adapter also has a 50-pin female
connector (J2) that carries 8-bit SCSI signals from the
MVME2603/2604. To run SCSI devices, you may install an
additional transition module that is equipped with a SCSI port,
such as the MVME712B.
Preparation of the P2 adapter for the MVME761 consists of
installing a jumper on header J1 to enable the SCSI terminating
resistors if necessary. Figure 1-16 illustrates the location of the
jumper header, resistors, fuse, and connectors.
J1
2
1
SCSI Enabled
(factory configuration)
J1
2
1
SCSI Disabled