Hardware Preparation and Installation
1
P2 Adapter Preparation (Three-Row)
1-32
The P2 adapter for the MVME761 transition module routes the
synchronous and asynchronous serial, parallel, and Ethernet signals to the
MVME761. The P2 adapter also has a 50-pin female connector (J2) that
carries 8-bit SCSI signals from the MVME2603/2604. To run SCSI
devices, you may install an additional transition module that is equipped
with a SCSI port, such as the MVME712B.
Preparation of the P2 adapter for the MVME761 consists of installing a
jumper on header J1 to enable the SCSI terminating resistors if necessary.
Figure 1-16
illustrates the location of the jumper header, resistors, fuse,
and connectors.
J1
2
1
SCSI Enabled
(factory configuration)
J1
2
1
SCSI Disabled
Computer Group Literature Center Web Site