Installing The Lsi 2008 Sas Mezzanine Card; Cable Routing For Lsi 2008 Sas Mezzanine Card (1U Node) - Dell PowerEdge C6320 Owner's Manual

Installing the LSI 2008 SAS mezzanine card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Place the LSI 2008 SAS mezzanine card on the system-board assembly.
2. Install the three screws that secure the LSI 2008 SAS mezzanine card.
3. Reconnect all the cables to the LSI 2008 SAS mezzanine card.
4. Replace the system-board assembly.
Related Information
Installing a system-board assembly

Cable routing for LSI 2008 SAS mezzanine card (1U Node)

1. Connect the mini-SAS&SGPIO cable to the LSI 2008 SAS Mezzanine card, and connect the other end
of the cable to the corresponding connectors on the system board.
2. Connect the mini-SAS cable to the LSI 2008 SAS Mezzanine card, and connect the other end of the
cable to the corresponding connector on the system board.
NOTE: The SGPIO cable must be connected before the LSI 2008 SAS Mezzanine card is
installed.
Figure 47. Cable routing for LSI 2008 SAS mezzanine card (1U node)
Item
3. Press down on the cables, and ensure the cables are routed lower than the height of the CPU heat
sinks.
78
Cable
Mini-SAS/SGPIO cable
Mini-SAS cable
From (LSI 2008 SAS
mezzanine card)
Mini-SAS connector
4~7 (J4)
Mini-SAS connector
0~3 (J3)
To (system board)
SAS/SATA input
connector 4 and SAS/
SATA input connector 5
Mini SAS HD connector
0-3