Table of Contents
Advertisement
Figure 44. Removing the mezzanine card
Next steps
Install the mezzanine
card.
Installing the mezzanine card
Prerequisites
NOTE:
You must remove the mezzanine card to replace a faulty mezzanine card or service other components inside the
system.
Follow the safety guidelines listed in
Steps
1. Open the retention latch by pressing the ridged area on the retention latch with your thumb and lifting the end of the latch.
2. If present, remove the connector cover from the mezzanine card bay.
CAUTION:
To prevent damage to the mezzanine card, you must hold the card only by its edges.
3. Rotate the card to align the connector on the bottom of the mezzanine card with the corresponding socket on the system board.
4. Lower the card into place until it is fully seated and the plastic clip on the outer edge of the card engages over the side of the system.
5. Close the retention latch to secure the mezzanine card.
84
Installing and removing system components
Safety instructions
on page 46.
Advertisement
Table of Contents
