Installing An Expansion Card Or Gpu Into The Expansion Card Riser 2 - Dell PowerEdge XR7620 Installation And Service Manual

NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 103. Installing the riser blank
Next steps
If applicable, Install an expansion card into the expansion card riser 2

Installing an expansion card or GPU into the Expansion card riser 2

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installing a new expansion card, unpack it and prepare the card for installation.
NOTE: For instructions, see the documentation accompanying the card.
4. Remove the 2U air shroud.
5. Remove the drive cage.
NOTE: The procedure to install the expansion card or GPU is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Pull and lift up the expansion card retention latch locks to open. If installed, remove the filler bracket.
NOTE: Store the riser blanks for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
134 Installing and removing system components
Safety instructions.
Before working inside your
or Install the expansion card riser
system.
2.