Removing The Raid Battery Holder - Dell PowerEdge C8220 Hardware Owner's Manual

Removing the RAID Battery Holder

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 143.
2 Remove the front cover. See "Removing the Front Cover" on page 148.
3 Remove the RAID battery. See "Removing the RAID Battery" on page 169.
4 Remove the three screws and hex nuts securing the battery holder to the
mounting board. See Figure 3-22.
5 Remove the battery holder. See Figure 3-22.
Figure 3-22. Removing and Installing the Battery Holder
1 mounting board
3 M3 screws (3)
172
Installing System Components
Many repairs may only be done by a certified service technician. You
1
4
2 M2 hex nuts (3)
4 battery holder
2
3