Figure 43. Installing the storage controller card
Next steps
1. Install the following:
a.
Drive backplane
b.
Drive cage
c.
Drives
2. Follow the procedure listed in
Removing the RAID controller battery
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the following:
a.
Drives
b.
Drive backplane
c.
Drive cage
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage controller
card.
CAUTION:
To prevent damage to the storage controller card, you must hold the card only by its edges.
After working inside your system
Safety instructions
on page 45.
Before working inside your system
on page 46.
on page 45.
Installing and removing system components
81