Application Network Setting - AudioCodes Mediant 2000 User Manual

SIP User's Manual
3.3.5.4.2 Configuring DTMF and Dialing Parameters
The 'DTMF & Dialing' page is used to configure parameters associated with dual-tone multi-
frequency (DTMF) and dialing. For a description of the parameters appearing on this page,
refer to ''Configuration Parameters Reference''

To configure the DTMF and dialing parameters:
1. Open the 'DTMF & Dialing' page (Configuration tab > Protocol Configuration menu
> Protocol Definition submenu > DTMF & Dialing
2. Configure the parameters as required.
3. Click the Submit
4. To save the changes to flash memory, refer to ''
3.3.5.5

Application Network Setting

The Application Network Setting
domains and interfaces. This submenu contains the following page items:

SRD Table (refer to ''

SIP Interface Table (refer to ''Configuring the SIP Interface Table''
3.3.5.5.1 Configuring the Signaling Routing Domain Table
The 'SRD Table' page allows you to configure up to five signaling routing domains (SRD).
An SRD is a set of definitions of IP interfaces, device resources, SIP behaviors and other
definitions that together create (from the IP user's perspective) from one physical device,
multiple virtual multi-service gateways.
SRD provides the following:

Multiple, different SIP signaling (SRD associated with a SIP Interface) and RTP media
(associated with a Media Realm) interfaces for multiple Layer-3 networks.

Ability to operate with multiple gateway customers that may reside either in the same
or in different Layer-3 networks as the device. This allows separation of signaling
traffic between different customers. In such a scenario, the device is configured with
multiple SRD's.
Version 6.0
Figure 3-59: DTMF & Dialing Page
button to save your changes.
submenu allows you to configure SIP signaling routing
Configuring the Signaling Routing Domain Table''
101
3. Web-Based Management
on page 223 .
page item).
Saving Configuration'' on page 172 .
on page 101 )
on page 102 )
March 2010