Refitting The Driven Pulley Shaft Bearing; Baffle Roller; Plastic Roller - Gilera Nexus 500 Workshop Manual

Nexus 500

Refitting the driven pulley shaft bearing

- Heat the transmission cover interior using the
heat gun.
N.B.
BE CAREFUL NOT TO OVERHEAT THE COV-
ER AS THIS WOULD DAMAGE THE OUTSIDE
PAINTED SURFACE.
Specific tooling
020151Y Air heater
- Place the bearing onto the special tool with a little
grease to prevent it from coming out.
- Install the new bearing using the special tool.
N.B.
PROPERLY SUPPORT THE OUTSIDE COVER
TO PREVENT DAMAGING THE PAINTED SUR-
FACE.
Specific tooling
020376Y Adaptor handle
020358Y 37x40-mm adaptor
020439Y 17 mm guide

Baffle roller

Plastic roller

Installation of belt anti-vibration roller
- Install the anti-flapping roller with the lip facing
the engine crankcase.
- Tighten the central screw to the prescribed tor-
que.
N.B.
TURN THE DRIVEN AND/OR DRIVING PULLEY
UNTIL A CORRECT TENSIONING OF THE
BELT IS OBTAINED.
Locking torques (N*m)
Anti-vibration roller screw 16.7 - 19.6
Engine
ENG - 5