Gilera Nexus 500 Workshop Manual page 278

Injection
Repeat the wiring and sensor continuity checks.
YES go to 18
18
Electric characteristic
Measured value =
0 V
Repeat the sensor circuit earth insulation check.
YES go to 19 NO go to 20
19 - Check the control unit connector. Check the control unit power supply. Replace the control unit, if
necessary.
20 - Repair or replace the cable harness.
21 - Start the engine and check that voltage decreases gradually according to the air filter box temper-
ature increase.
N.B.
WITH MILD WEATHER, 30° C CAN BE EASILY REACHED AFTER A FEW MINUTES OF STOP
WITH IDLE ENGINE.
Pressure sensor
This sensor does not have a system since it is di-
rectly installed into the control unit.
The sensor allows the control unit to optimise the
engine performance based on altimetric varia-
tions.
To check the sensor, proceed as follows:
1 - Connect the diagnostic tester.
Select the function "ERRORS" in the menu.
Check whether there are any indications regarding
the pressure sensor.
YES go to 2 NO go to 3
Specific tooling
020460Y Scooter diagnosis and tester
2 - Replace the injection control unit.
3 - Select the menu on the "PARAMETERS" function.
Check that the pressure value in mm/Hg matches that of another scooter or of an external barometer.
Electric characteristic
Max error:
± 20 mmHg
INJEC - 86
Nexus 500