Refitting The Front Wheel; Front Fork - Gilera Nexus 500 Workshop Manual

Suspensions
- Upturn the wheel and insert the inside spacer
with the portion provided with snap ring facing the
LH bearing installed before.
- Heat the bearing seat on the odometer motion
drive side using the thermal gun.
- Insert the 2 bearings by the punch consisting of
adapter handle, adapter 32x35 mm and 15-mm
guide to abutment.
Specific tooling
020376Y Adaptor handle
020357Y 32 x 35 mm adaptor
020412Y 15 mm guide
- Check that the wheel axle is free from wear or deformations. Replace them, if necessary.

Refitting the front wheel

- To refit, carry out the removal operations but in
reverse order, observing the prescribed torques.
- Place the odometer movement sensor until the
reference correctly fits into its slot.
Locking torques (N*m)
Front wheel shaft 45 ÷ 50 Safety screw on fork
leg 6 ÷ 7

Front fork

SUSP - 4
Nexus 500