Rear Brake Disc - Gilera Nexus 500 Workshop Manual

Braking system
TO AVOID DAMAGING THE GASKETS, WASH THE PLIERS COMPONENTS ONLY WITH ALCO-
HOL. DO NOT USE FUEL OR DERIVATIVES.
Refitting
- Attach the sliding plate of the front brake calliper
to the fork using the two screws with lock washers
tightened to the specified torque.
- Connect the brake pipe to the calliper and tighten
it to the prescribed torque, turning the fitting to-
wards the front and parallel to the scooter axis as
shown in the photo.
Locking torques (N*m)
Pipe joint / brake calliper 20 ÷ 25

Rear brake disc

Removal
- Remove the rear brake calliper
- Remove the brake disc with hub from the wheel
axle.
- To remove the brake disc from the hub, support
the unit in a vice and tighten the 5 fastening bolts
with self-locking nuts.
Refitting
- To reassemble the brake disc on the hub, carry
out the removal operations in the reverse order ar-
ranging the brake disc on the hub on the side
opposed the wheel keying
- Follow the direction of rotation shown by the ar-
row and tighten to the prescribed torque.
- Lubricate the seat of the wheel bearing shaft on
the manifold support with the recommended
grease.
N.B.
BRAK SYS - 8
Nexus 500