Refitting The Timing Chain; Prescribed Clearance - Gilera Nexus 500 Workshop Manual

Nexus 500
Loctite 243 Medium-strength threadlock
Loctite 243 medium-strength threadlock
- Check that the decompression mass is free and
that it is pulled by the spring.
Locking torques (N*m)
Valve lifter mass stop bell fixing screws: 30 -
35
- Place the engine with the valve clearance adjustment timing references aligned with the head.
- Check the clearance between valve and rocking lever using a thickness gauge.
Specification
drainage
- In case different values are found, adjust by loos-
ening the lock nut and use a screwdriver for the set
screw as shown in the figure.

Refitting the timing chain

The ignition advance is determined electronically on the basis of parameters known by the control unit.
For this reason it is not possible to declare the reference values based on the engine rpm.
The ignition timing value is detectable any time using the diagnostic tester.
It is possible to check whether the ignition advance determined by the system does in fact correspond
with the value actually activated on the engine, by means of the stroboscopic light.
Specific tooling
020460Y Scooter diagnosis and tester
020330Y Stroboscopic light for timing control

PRESCRIBED CLEARANCE

Inlet
Desc./Quantity
0.15 mm (engine cold)
0.15 mm (engine cold)
Engine
ENG - 79