Zeroing; Programming - Gilera Nexus 500 Workshop Manual

Electrical system

Zeroing

- Remove the front shield to gain access to the re-
ceiver control unit / seat opener controller.
- Within the electrical wiring harness there are two
cables, one black (ground) and one black/blue
coming from pin 3 of the control unit.
- Connect the two cables for at least 10 seconds
to cancel all the remote control commands stored
in the control unit.

Programming

- Follow these steps to program the remote controls:
1. Insert the remote control key to be programmed in the steering lock key block.
2. Turn the key to ON, press the button of the remote control, release the button, turn the key from ON
back to OFF, all within four seconds.
3. Wait for 1 to 8 seconds.
4. Repeat steps 2 and 3 for 4 times without removing the key. The control unit confirms the programming
has been successfully executed by opening the saddle.
N.B.
THE CONTROL UNIT CAN PROGRAMME UP TO 7 REMOTE CONTROLS.
ELE SYS - 28
Nexus 500