Transmissions; Capacity; Electrical System - Gilera Nexus 500 Workshop Manual

Characteristics
Specification
Timing system
Valve clearance: intake:
Valve clearance: exhaust
Valve clearance adjustment
Engine idle speed
Air filter
CO % value (measured at the intake manifold)
Starting system
Lubrication
Lubrication pressure
Minimum allowed (at 100° C)
Fuel supply
Max. power (at crankshaft)
Max. torque (at crankshaft)
Cooling system
Transmission
Specification
Transmission
Capacities
Specification
Engine oil (dry)
Engine oil (at oil and filter change)
Fuel tank (including reserve approx. 2 litres)
Rear hub
Cooling system
Front fork

Electrical system

Specification
Electronic ignition
Spark plug
CHAR - 4
Single overhead camshaft with integrated tone
wheel, control from flywheel side chain, 4 valves
and automatic start-up valve lifting device.
By threaded adjuster on the rockers
Electric starter system with freewheel.
By trochoidal pump (inside the crankcase), pres-
sure adjustment by-pass and oil filter.
Electronic injection system with electric fuel pump,
Ø 38 mm throttle body and single injector.
Fluid circulation through a motor-driven pump, 3-
way thermostat and electric fan.

TRANSMISSIONS

With automatic expandable pulley variator with tor-
que server, V belt, automatic clutch, gear reduc-
tion unit and transmission housing with forced air

CAPACITY

approx. 242 ± 3 cc (in each fork leg)
ELECTRICAL SYSTEM
inductive, high efficiency integrated with the injec-
tion system, with variable timing and separate HV
Nexus 500
Desc./Quantity
0.15 mm (when cold)
0.15 mm (when cold)
1500 ± 50 rpm
Dry paper filter.
1 ÷ 1.5%
4 bar
0.8 bar
29.5 kW at 7500 rpm
43 Nm at 5500 rpm
Desc./Quantity
circulation cooling.
Desc./Quantity
~ 1.7 litres
approx. 1.5 litres
approx. 14.5 litres
approx. 250 cc.
approx. 1.8 litres
Desc./Quantity
coil.
NGK CR7EKB