Table of Contents
Advertisement
2. Use the setsnmpvacm(8) command to set VACM management information.
<Example 1>
XSCF> setsnmpvacm creategroup -u yyyyy xxxxx
<Example 2>
XSCF> setsnmpvacm deletegroup -u yyyyy xxxxx
<Example 3>
XSCF> setsnmpvacm createview -s .1 all_view
<Example 4> Create an MIB access control view by using an OID mask.
XSCF> setsnmpvacm createview -s .1.3.6.1.2.1 -m fe excl_view
<Example 5>
XSCF> setsnmpvacm deleteview -s .1.3.6.1.2.1 excl_view
<Example 6>
XSCF> setsnmpvacm createaccess -r all_view xxxxx
<Example 7>
XSCF> setsnmpvacm deleteaccess group1
3. Use the showsnmpvacm(8) command to confirm the settings.
XSCF> showsnmpvacm
2.2.12
Mail Administration
The mail report function is used to send an email to the system administrator when
the fault has occurred in the system. This section explains how to set up the XSCF
mail report function.
Note – You should set up the mail configuration so the designated users (platadm,
system administrators, and so on) can receive immediate notification of faults that
occur on the platform or domain.
Add a user to an access control group xxxxx.
Delete a user from an access control group xxxxx.
Create an MIB access control view without conditions.
Delete an MIB access control view.
Provide an MIB access control view to a group.
Delete a group from all MIB access control views.
Chapter 2
Setting Up XSCF 2-143
Advertisement
Table of Contents
