Table of Contents
Advertisement
After login, if the shell has not been accessed for a certain period, XSCF
■
automatically terminates the shell. The default timeout period is 10 minutes. The
timeout period can be specified. For details on specifying the timeout period, see
Chapter
In one domain, only one user can use the RW console (write-enabled console).
■
While one user is using the RW console, another user cannot start another RW
console in the same domain. For details on console connection, see
When a login fails, see
■
Note – In this manual, the window of the XSCF Shell terminal is called the XSCF
console.
5.2.2
Operation From a Terminal Connected to the
Serial Port
This section describes how to log in from a terminal connected to the serial port.
1. After the terminal is connected to the serial port, press the Enter key on the
terminal.
2. Enter a user account and password when prompted by XSCF.
3. Enter XSCF commands at the shell prompt (XSCF>) that is displayed after login
to XSCF.
The following is a login example:
login: jsmith
Password: xxxxxxxx
XSCF>
5.2.3
Operation for Connecting Via the XSCF-LAN
(SSH)
This section describes how to log in to XSCF through an XSCF-LAN (SSH)
connection.
1. Before logging in using SSH, check that the fingerprint is pre-stored. If you did
not save the fingerprint, please connect to the serial port and use showssh(8) to
make a memo of the fingerprint of the host public key.
5-8
SPARC Enterprise Mx000 Servers XSCF User's Guide • January 2012
2.
Appendix
D.
Chapter
3.
Advertisement
Table of Contents
