Table of Contents
Advertisement
Note – The display might be different according to XCP version and system
configuration.
At this time, the XSCF will reset and the XSCF session will disconnect, so
please connect the XSCF again. Only the application of the XSCF firmware is
completed.
Note – The work described below applies to a system with redundant XSCF Units.
i) Before updating the firmware, perform the showhardconf(8) command and
check the Status of the XSCF Unit 0/1, which is Active or Standby.
ii) Perform the firmware update in order, beginning with the standby side and then
the active side automatically. After the update on the standby side is completed, the
active and standby sides are switched. At this time, the XSCF reset is done and the
XSCF session is disconnected.
iii) Re-connect the XSCF and log in again.
iv) XSCF firmware update is completed.
v) When the firmware update completes, the active and the standby states of the
XSCF unit have become the opposite of original state. For instance, if the firmware
update is executed on XSCFU#0, when completing the command, XSCFU#1 would
become the active side. To switch the XSCF, execute the switchscf (8) command.
To confirm the switching between XSCFs, execute the showhardconf (8) command
and check the Status of the XSCF Unit 0/1, which is Active or Standby.
<Example>
XSCF> switchscf -t Standby
The XSCF unit switch between the Active and Standby states. Continue? [y|n] :y
d. To confirm that the XSCF firmware update has finished, use the
showlogs(8) command with the monitor option. Confirm no abnormality is
found during the update. If the "XCP update has been completed" message
is displayed in each XSCF Unit, the firmware update has completed.
XSCF> showlogs monitor
:
Jun 20 07:25:48 FF1-1-0 monitor_msg: SCF:XCP update has been
completed (XCP version=1082)
4. To complete the update of the OpenBoot PROM firmware, restart the domain.
Chapter 8
Upgrade of XSCF Firmware and Maintenance
8-17
Advertisement
Table of Contents
