Table of Contents
Advertisement
Configuring XSCF Routing
In a redundant XSCF unit configuration, the following are examples of data when
routing is done in each subnet.
<Example>
XSCF Unit 0
xscf#0-lan#0 [192.168.1.10] xscf#1-lan#0 [192.168.1.20]
+------------------------------+
XSCF-LAN#0
XSCF Unit 0
xscf#0-lan#1 [10.12.108.10] xscf#1-lan#1 [10.12.108.20]
+------------------------------+
XSCF-LAN#1
Destination
[192.168.1.0]
[default]
[192.168.1.0]
[default]
[10.12.108.0]
[default]
[10.12.108.0]
[default]
Note – The method of determining the routing for an XSCF interface depends on
the network environment at the installation site. The network environment for
system operation must have a suitable configuration.
Note – You cannot set the routing to the takeover IP address.
Command operation
■
1. Use the showroute(8) command to display the routing environment.
XSCF> showroute -a
Destination
Gateway
10.12.108.0
*
default
10.12.108.1
:
XSCF Unit 1
XSCF-LAN#0
XSCF Unit 1
XSCF-LAN#1
Gateway
Netmask
-
[255.255.255.0] xscf#0-lan#0
[192.168.1.1]
[0.0.0.0]
-
[255.255.255.0] xscf#1-lan#0
[192.168.1.1]
[0.0.0.0]
-
[255.255.255.0] xscf#0-lan#1
[10.12.108.1]
[0.0.0.0]
-
[255.255.255.0] xscf#1-lan#1
[10.12.108.1]
[0.0.0.0]
Netmask
255.255.255.0
0.0.0.0
Interface
xscf#0-lan#0
xscf#1-lan#0
xscf#0-lan#1
xscf#1-lan#1
Flags Interface
U
xscf#0-lan#0
UG
xscf#0-lan#0
Chapter 2
Setting Up XSCF
2-29
Advertisement
Table of Contents
