Fujitsu SPARC EnterpriseM3000 User Manual page 50

8. Configure the network.
• Display and set the DSCP
• Display XSCF network settings (enable/disable, IP
address, netmask) and configure/remove an XSCF
network.
• Display and set XSCF host name.
• Display XSCF route settings (destination IP address,
gateway, netmask, interface) and configure an XSCF
route.
• Display and make the DNS settings (name servers,
search paths, add/delete).
• Display and set the IP packet filtering rules.
• Apply network settings.
Perform the applynetwork(8) command to apply the network settings. To
■
complete the network settings, the XSCF reset is required. Go to the next step
when you reset it later. When you want to reset it now, perform the
rebootxscf(8) command to apply the settings. Then, the XSCF reset is done and
the XSCF session is disconnected. Please connect the XSCF and log in to the XSCF
again.
Here, when you set up the XSCF by the XSCF-LAN connection, please change the
■
cable from the serial port to the XSCF-LAN port. (Change the serial cable to the
LAN cable.) When you use the controller that converts the RS-232C interface and
LAN interface, you do not need to change the cable. Reconnect to the XSCF using
the new user account and the new IP address and login to the XSCF again.
For details on connecting the SSH, telnet, and serial port, and login to the XSCF,
see Chapter 3. Moreover, the telnet connection is not a secure connection protocol.
We recommend that you use SSH.
During login using SSH on XSCF Shell (Ethernet connection), you are prompted
to confirm the authenticity of the fingerprint of the host public key. The reply is
"yes" if the fingerprint is the same as the memo in
same, please confirm that the IP address is correct and not duplicated. There is a
possibility that IP address spoofing has occurred.
.
showdscp(8), setdscp(8),
shownetwork(8),
setnetwork(8)
showhostname(8),
sethostname(8)
showroute(8), setroute(8)
shownameserver(8) ,
setnameserver(8)
showpacketfilters(8) ,
setpacketfilters(8)
applynetwork(8)
(See Section 2.2.1, "Network
Configuration" on page
Step 6. If the reply is not the
Chapter 2 Setting Up XSCF
2-16)
2-7