Table of Contents
Advertisement
2. Use the setldapssl(8) command to set the log detail level.
<Example1> Enable the log and trace is set for detail level.
XSCF> setldapssl logdetail trace
<Example2> Disable the log.
XSCF> setldapssl logdetail none
3. Use the showldapssl(8) command to confirm the log detail level.
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
Display the Diagnostic Messages and Clear the Log File
■
1. Use the showldapssl(8) command to display the log detail level.
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
2. Use the showldapssl(8) command to display the diagnostic messages.
<Example> Displays diagnostic messages in real time.
XSCF> showldapssl log -f
Mon Nov 16 14:47:53 2009 (LdapSSL): module loaded, OPL
Mon Nov 16 14:47:53 2009 (LdapSSL): --error-- authentication
status: auth-ERROR
Mon Nov 16 14:48:18 2009 (LdapSSL): module loaded, OPL
...
3. Use the setldapssl(8) command to clear the log file of diagnostic messages.
XSCF> setldapssl log clear
Warning: About to clear log file.
Continue? [y|n]: y
2-90
SPARC Enterprise Mx000 Servers XSCF User's Guide • January 2012
Command operation
Advertisement
Table of Contents
