Information To Have Available; Configuring The Site-To-Site Vpn; Starting Asdm; Configuring The Security Appliance At The Local Site - Cisco ASA 5505 Getting Started Manual

Chapter 10 Scenario: Site-to-Site VPN Configuration

Information to Have Available

Configuring the Site-to-Site VPN

Starting ASDM

78-18003-02
Before you begin the configuration procedure, obtain the following information:
IP address of the remote adaptive security appliance peer
•
IP addresses of local hosts and networks permitted to use the tunnel to
•
communicate with resources at the remote site
IP addresses of remote hosts and networks permitted to use the tunnel to
•
communicate with local resources
This section describes how to use the ASDM VPN Wizard to configure the
adaptive security appliance for a site-to-site VPN.
This section includes the following topics:
Starting ASDM, page 10-3
•
Configuring the Security Appliance at the Local Site, page 10-5
•
Providing Information About the Remote VPN Peer, page 10-7
•
Configuring the IKE Policy, page 10-8
•
Configuring IPsec Encryption and Authentication Parameters, page 10-10
•
Specifying Hosts and Networks, page 10-11
•
Viewing VPN Attributes and Completing the Wizard, page 10-12
•
The following sections provide detailed instructions for how to perform each
configuration step.
This section describes how to start ASDM using the ASDM Launcher software.
If you have not installed the ASDM Launcher software, see Installing the ASDM
Launcher, page 5-5.
If you prefer to access ASDM directly with a web browser or using Java, see
Starting ASDM with a Web Browser, page 5-8.
To start ASDM using the ASDM Launcher software, perform the following steps:
Implementing the Site-to-Site Scenario
ASA 5505 Getting Started Guide
10-3