Adjustment Outline; Adjustment Tools - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000

5.1 Adjustment Outline

This section describes the adjustment procedures necessary after replacing
certain parts and explains how to perform those adjustment procedures.
Before beginning any adjustment procedure, make sure of the following.
!
Before starting any adjustment procedure, find the
C A U T I O N
adjustment procedure you need to perform in Table 5-2 on
page 155 and verify the order or the tasks you need to
perform.
!
When performing an adjustment procedure, double-check
the detailed instructions and caution information for that
procedure; otherwise you may damage the printer.
!
To make proper adjustment, make sure to avoid strong
light (sun-light) around the printer. Since this printer uses
photo-sensitive devices (photo-sensors), the printer may
not function properly if it is operated under such
conditions.
!
When replacing the following, always install a new ink
cartridge.
• Printheads
• Main Board
• "Holder, Assembly, Valve"
Adjustment

5.1.1 Adjustment Tools

The necessary tools for performing adjustment procedures on this printer are
shown below.
Name
Tension Gauge
Tension Gauge
#F712
Straight edge/ruler
1000mm #F713
Scale Stopper
Flash Memory Card
#F727
Self-Training Kit
#F708
Adjustment Outline
Table 5-1. Adjustment Tools
Part Code Notes
1054053/
standard tool Max. 10,000g
acceptable
B747700300/
standard tool Max. 2500g
acceptable
1047746/
standard tool Length: 1000mm
acceptable
1047745/
Used in combination with #F713
standard tool
(0.1mm scale)
acceptable
1050073 Type: 2MB Flash memory card
standard Standard: Type-II (PCMCIA Rel 2.1/
JEIDA Ver. 4.2)
PC card
acceptable Voltage: 5V Read/Write
1047105 CD-ROM based
Revision A
154