Video Setup Menu - Sony SRW-1 Operation Manual

4-3 VIDEO Setup Menu

The VIDEO Setup menu allows you to make settings
related to video signals.
In the Settings column of the following table:
Item
PD(MON) OUTPUT
DC TYPE
POS(EC)
MON SEL(x2) TYPE
VIDEO I/O VA INPUT
CAM TYPE Selects the type of connected camera, when CAM is selected under VA INPUT.
Settings
Selects whether to perform pulldown conversion of output to the MONITOR OUT HD SDI
connector
AUTO [Auto]: Convert when the frame frequency is 23.98 Hz. Otherwise, do not convert.
THRU [Through]: Do not convert.
Selects the downconvert mode.
LB [Letter Box]: Letter Box mode
EC [Edge Crop]: Edge Crop mode
SQ [Squeeze]: Squeeze mode
When TYPE is set to EC, adjusts the H crop (horizontal width of extracted sections in Edge Crop
mode) of downconverter output.
–120 to 120 (0)
When 4:2:2 DUAL STREAM is selected, selects the signal output from the MON OUT HD SDI
connector.
LINKA [Link-A]: E-E output of the signal input from the HD SDI IN A connector, or playback output
of the recorded signal
LINKB [Link-B]: E-E output of the signal input from the HD SDI IN B connector, or playback output
of the recorded signal
Selects the input interface.
CAM [CAM(Optical): CAMERA connector (only when optional HKSR-101 is installed)
SDI [SDI Input]:HD SDI IN A/B connectors
F950 [F950]: When using the HDC-F950.
STD [Standard]: When using a recommended optically-connectable camera.
Contact a Sony service representative for details about optically-connectable cameras.
• Default settings are underlined.
• Square brackets indicate settings as displayed in setting
windows (see the figure for step 3 on page 55).
47
4-3 VIDEO Setup Menu