Connecting Reference Signals (Examples For When External Sync Is Required) - Sony SRW-1 Operation Manual

3-3-2 Connecting Reference Signals
Required)
Connect reference signals as explained below, depending
on how you want to use the system.
Connections to record signals from cameras, switchers, signal generators, etc.
In the SYSTEM Setup menu, set REFERENCE >MODE
to "Input" (see page 48), and then connect as shown below.
In the SYSTEM Setup menu, set
REFERENCE >MODE to "Input."
Connections to record using optical-fiber cable
To record using an optical-fiber connection between this
unit and the HDC-F950 camera, with the optional HKSR-
101 installed in the SRPC-1, the first step is to synchronize
by supplying reference signals from this unit to the HDC-
F950 over the optical-fiber cable. Next, output signals
from the synchronized HDC-F950 are input to this unit,
replacing the reference signals of this unit.
If you do not want to input external reference signals to
this unit, set REFERENCE >MODE (see page 48) in the
SYSTEM Setup menu to "Input".
HDC-F950 multi-format
camera system
(Examples for When External Sync Is
HD SDI IN A/B
(A only or A/B)
SRW-1 + SRPC-1
CCU
FC2-PD50/PD250 Optical-Fiber
Cable (optional).
Reference signals
Camera, switcher, signal
generator, etc.
REF IN, GENLOCK IN
When you need to input external reference
signals to this unit
Set REFERENCE >MODE in the SYSTEM Setup menu
to "External", and set REFERENCE >EXTERNAL to the
appropriate value for the reference signals that you are
using (see page 48).
If you want to input an HD tri-level sync signal to the REF
IN HD connector, set REFERENCE >EXTERNAL to
"HD" and make the connections shown below.
CAMERA
REF IN HD
SRW-1 + SRPC-1
+ HKSR-101 (optional)
HD SDI OUT A/B
(A only or A/B)
Reference signals
In the SYSTEM Setup menu,
set REFERENCE
>EXTERNAL to "HD".
3-3 About Reference Sync Signals
29