Configuring Snmp; Figure 529 System > Snmp; Table 251 System > Snmp - ZyXEL Communications ZyWALL USG 100 Series User Manual

Chapter 44 System

44.10.3 Configuring SNMP

To change your ZyWALL's SNMP settings, click System > SNMP tab. The screen appears as
shown. Use this screen to configure your SNMP settings, including from which zones SNMP
can be used to access the ZyWALL. You can also specify from which IP addresses the access
can come.
Figure 529 System > SNMP
The following table describes the labels in this screen.
Table 251 System > SNMP
LABEL
Enable
Server Port
Get Community
Set Community
Trap
Community
Destination
Service Control
#
Zone
Address
Action
708
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ZyWALL
using this service.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from
the management station. The default is private and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
This specifies from which computers you can access which ZyWALL zones.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-configurable)
default policy. The ZyWALL applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ZyWALL will not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
This displays whether the computer with the IP address specified above can access
the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
ZyWALL USG 100/200 Series User's Guide