Configuring An Active-Passive Mode Monitored Interface; Figure 442 Device Ha > Active-Passive Mode > Edit; Table 194 Device Ha > Active-Passive Mode > Edit - ZyXEL Communications ZyWALL USG 100 Series User Manual

Chapter 35 Device HA
Table 193 Device HA > Active-Passive Mode (continued)
LABEL
Auto
Synchronize
Interval
Apply
Apply & switch to
Active-Passive
Mode
Reset

35.4 Configuring an Active-Passive Mode Monitored Interface

The Device HA Active-Passive Mode Monitored Interface Edit screen lets you enable or
disable monitoring of an interface and set the interface's management IP address and subnet
mask. To access this screen, click Device HA > Active-Passive Mode > Edit.
Figure 442 Device HA > Active-Passive Mode > Edit
The following table describes the labels in this screen.
Table 194 Device HA > Active-Passive Mode > Edit
LABEL
Enable
Monitored
Interface
Interface Name
Virtual Router IP
(VRIP) / Subnet
Mask
Manage IP
Subnet Mask
OK
Cancel
592
DESCRIPTION
Select this to get the updated configuration automatically from the specified
ZyWALL according to the specified Interval. The first synchronization begins after
the specified Interval; the ZyWALL does not synchronize immediately.
When you select Auto Synchronize, set how often the ZyWALL synchronizes with
the master.
This appears when the ZyWALL is currently using active-passive mode device HA.
Click Apply to save your changes back to the ZyWALL.
This appears when the ZyWALL is currently configured for legacy mode device HA.
Click Apply to save your changes back to the ZyWALL and set it to use active-
passive mode device HA.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select this to have device HA monitor the status of this interface's connection.
This identifies the interface.
This is the interface's (static) IP address and subnet mask in the virtual router.
Whichever ZyWALL is currently serving as the master uses this virtual router IP
address and subnet mask. These fields are blank if the interface is a DHCP client
or has no IP settings.
Enter the interface's IP address for management access. You can use this IP
address to access the ZyWALL whether it is the master or a backup. This
management IP address should be in the same subnet as the interface IP address.
Enter the subnet mask of the interface's management IP address.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
ZyWALL USG 100/200 Series User's Guide