Vpn Express Wizard - Remote Gateway; Figure 36 Vpn Express Wizard: Step 3; Table 15 Vpn Express Wizard: Step 2 - ZyXEL Communications ZyWALL USG 100 Series User Manual

Table 15 VPN Express Wizard: Step 2 (continued)
LABEL
Pre-Shared
Key
Next

4.8 VPN Express Wizard - Remote Gateway

The Remote Gateway policy identifies the IPSec devices at either end of a VPN tunnel.
Name: Type the name used to identify this VPN connection (and VPN gateway). You may use
1-31 alphanumeric characters, underscores(
number. This value is case-sensitive.
Secure Gateway: Enter the WAN IP address or domain name of the remote IPSec router
(secure gateway). Use 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address and
no domain name.
Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal ("0-9", "A-F")
characters. Proceed hexadecimal characters with "0x".

Figure 36 VPN Express Wizard: Step 3

ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with "0x".
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
Click Next to continue.
), or dashes (-), but the first character cannot be a
_
Chapter 4 Wizard Setup
99