The following table describes the screens in this screen.
Table 171 Anti-X > ADP > General
LABEL
General Settings
Enable Anomaly
Detection
Policies
Priority
From, To
Anomaly Profile
Add icon
Apply
Reset
31.2.1 Configuring ADP Policies
Click Anti-X > ADP > General and then an Add or Edit icon to display the following screen.
Use this screen to apply an ADP profile to a traffic direction.
Figure 405 Anti-X > ADP > General > Add
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select this check box to enable traffic anomaly and protocol anomaly
detection.
Use this list to specify which anomaly profile the ZyWALL uses for traffic
flowing in a specific direction.
This is the rank in the list of anomaly profile policies. The list is applied in order
of priority.
This is the direction of travel of packets to which an anomaly profile is bound.
Note: Depending on your network topology and traffic load,
applying every packet direction to an anomaly profile may
affect the ZyWALL's performance.
An anomaly profile is a set of anomaly rules with configured activation, log and
action settings. This field shows which anomaly profile is bound to which traffic
direction.
Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the entry is enabled or not. Click it to activate
or deactivate the entry. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the entry.
Click the Add icon in an entry to add an entry below the current entry.
Click the Remove icon to delete an existing entry from the ZyWALL. A window
displays asking you to confirm that you want to delete the entry. Note that
subsequent entries move up by one when you take this action.
In a numbered list, click the Move to N icon to display a field to type an index
number for where you want to put that entry and press [ENTER] to move the
entry to the number that you typed. For example, if you type 6, the entry you
are moving becomes number 6 and the previous entry 6 (if there is one) gets
pushed up (or down) one.
The ordering of your entries is important as they are applied in order of their
numbering.
Click Apply to save your changes.
Click Reset to start configuring this screen again.
Chapter 31 ADP
523