10.5.1 Interface Wizard: OPT Interface First Screen
This screen displays first when you use the interface wizard for the OPT interface.
Figure 153 Interface Wizard: OPT Interface First Screen
The following table describes the labels in this screen.
Table 52 Interface Wizard: OPT Interface First Screen
LABEL
Would you like to
configure OPT
interface as a
WAN interface?
Cancel
Next
10.5.2 Interface Wizard: WAN Type
This screen appears if you are configuring one of the WAN interfaces or you use the OPT
interface for a WAN connection. Select the type of encapsulation this interface uses for its
Internet connection.
Figure 154 Interface Wizard: WAN Type
The following table describes the labels in this screen.
Table 53 Interface Wizard: WAN Type
LABEL
WAN Type
Selection
Back
Next
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Select Yes to use the OPT interface as a WAN interface (for an Internet
connection).
select No to use the OPT interface for a local network (similar to a lan1, ext-wlan,
or dmz interface).
Click Cancel to exit the wizard without saving your changes.
Click Next to continue. If you selected Yes, go to
If you selected No, go to
Section 10.5.3 on page
DESCRIPTION
Choose the Ethernet option to use the WAN port as a regular Ethernet.
Otherwise, choose PPPoE or PPTP for a dial-up connection according to the
information from your ISP.
Click Back to return to the previous screen.
Click Next to continue. Go to
Section 10.5.2 on page
220.
Section 10.5.4 on page
221.
Chapter 10 Interface
219.
219