Figure 205 Network > Routing > Ospf > Edit; Table 97 Network > Routing > Ospf > Edit - ZyXEL Communications ZyWALL USG 100 Series User Manual

Chapter 13 Routing Protocols
Figure 205 Network > Routing > OSPF > Edit
The following table describes the labels in this screen.
Table 97 Network > Routing > OSPF > Edit
LABEL
Area ID
Type
Authentication
Text
Authentication
Key
MD5
Authentication ID
MD5
Authentication
Key
Virtual Link
#
Peer Router ID
298
DESCRIPTION
Type the unique, 32-bit identifier for the area in IP address format.
Select the type of area.
Normal - This area is a normal area. It has routing information about the OSPF AS
and about networks outside the OSPF AS.
Stub - This area is an stub area. It has routing information about the OSPF AS but
not about networks outside the OSPF AS. It depends on a default route to send
information outside the OSPF AS.
NSSA - This area is a Not So Stubby Area (NSSA), per RFC 1587. It has routing
information about the OSPF AS and networks that are outside the OSPF AS and
are directly connected to the NSSA. It does not have information about other
networks outside the OSPF AS.
Select the default authentication method used in the area. This authentication
protects the integrity, but not the confidentiality, of routing updates.
None uses no authentication.
Text uses a plain text password that is sent over the network (not very secure).
MD5 uses an MD5 password and authentication ID (most secure).
This field is available if the Authentication is Text. Type the password for text
authentication. The key can consist of alphanumeric characters and the
underscore, and it can be up to 8 characters long.
This field is available if the Authentication is MD5. Type the default ID for MD5
authentication in the area. The ID can be between 1 and 255.
This field is available if the Authentication is MD5. Type the default password for
MD5 authentication in the area. The password can consist of alphanumeric
characters and the underscore, and it can be up to 16 characters long.
This section is displayed if the Type is Normal. Create a virtual link if you want to
connect a different area (that does not have a direct connection to the backbone)
to the backbone. You should set up the virtual link on the ABR that is connected to
the other area and on the ABR that is connected to the backbone.
This field is a sequential value, and it is not associated with a specific area.
Type the 32-bit ID (in IP address format) of the other ABR in the virtual link.
ZyWALL USG 100/200 Series User's Guide