Vpn Advanced Wizard - Remote Gateway; Figure 40 Vpn Advanced Wizard: Step 3 - ZyXEL Communications ZyWALL USG 100 Series User Manual

Chapter 4 Wizard Setup

4.8.5 VPN Advanced Wizard - Remote Gateway

The Remote Gateway policy identifies the IPSec devices at either end of a VPN tunnel.
Name: Type the name used to identify this VPN connection (and VPN gateway). You may use
1-31 alphanumeric characters, underscores(
number. This value is case-sensitive.
Secure Gateway: Enter the WAN IP address or domain name of the remote IPSec router
(secure gateway). Use 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address and
no domain name.
Select an interface to use on your ZyWALL.
Select Pre-Shared Key to use a password for authentication. Both ends of the VPN tunnel
must use the same pre-shared key. Use 8 to 31 case-sensitive ASCII characters or 16 to 62
hexadecimal ("0-9", "A-F") characters. Precede hexadecimal characters with "0x".
Select Certificate to use a digital certificate for authentication. default uses the ZyWALL's
default certificate. Click Object > Certificate to configure other certificates in the My
Certificates screen.
4.8.5.1 Phase 1 Setting
There are two phases to every IKE (Internet Key Exchange) negotiation – phase 1
(Authentication) and phase 2 (Key Exchange). A phase 1 exchange establishes an IKE SA
(Security Association).

Figure 40 VPN Advanced Wizard: Step 3

104
), or dashes (-), but the first character cannot be a
_
ZyWALL USG 100/200 Series User's Guide