How To Set Up Available Bandwidth On Ethernet Interfaces; How To Configure The Load Balancing In The Wan Trunk; Figure 101 Network > Interface > Ethernet > Edit (Wan1) - ZyXEL Communications ZyWALL USG 100 Series User Manual

You do not have to change many of the ZyWALL's settings from the defaults to set up this
trunk. You only have to set up the bandwidth on wan1 and wan2 and change the algorithm that
WAN_TRUNK uses.

6.6.1 How to Set Up Available Bandwidth on Ethernet Interfaces

1 Click Network > Interface > Ethernet and the wan1 Edit icon. Enter the available
bandwidth (1000 kbps) in the Egress Bandwidth field. Click OK.
Figure 101 Network > Interface > Ethernet > Edit (wan1)
2 Click the Edit icon for wan2, and enter the available bandwidth (512 kbps) in the Egress
Bandwidth field. Click OK.

6.6.2 How to Configure the Load Balancing in the WAN Trunk

1 Click Network > Interface > Trunk. Click the Edit icon next to WAN_TRUNK.
2 In the Load Balancing Algorithm field, select Weighted Round Robin. After the
screen refreshes, enter 2 and 1 in the Weight column for wan1 and wan2, respectively.
Click OK.
ZyWALL USG 100/200 Series User's Guide
Chapter 6 Tutorials
159