Figure 441 Device Ha > Active-Passive Mode; Table 193 Device Ha > Active-Passive Mode - ZyXEL Communications ZyWALL USG 100 Series User Manual

Chapter 35 Device HA
Figure 441 Device HA > Active-Passive Mode
The following table describes the labels in this screen. See
information as well.
Table 193 Device HA > Active-Passive Mode
LABEL
Device Role
Priority
Preempt
Cluster Settings
Cluster ID
590
DESCRIPTION
Select the device HA role that the ZyWALL plays in the virtual router. Choices are:
Master - This ZyWALL is the master ZyWALL in the virtual router. This ZyWALL
uses the virtual IP address for each monitored interface.
Note: Do not set this field to Master for two or more ZyWALLs in the
same virtual router (same cluster ID).
Backup - This ZyWALL is a backup ZyWALL in the virtual router. This ZyWALL
does not use any of the virtual IP addresses.
This field is available for a backup ZyWALL. Type the priority of the backup
ZyWALL. The backup ZyWALL with the highest value takes over the role of the
master ZyWALL if the master ZyWALL becomes unavailable. The priority must be
between 1 and 254. (The master interface has priority 255.)
This field is available for a backup ZyWALL. Select this if this ZyWALL should
become the master ZyWALL if a lower-priority ZyWALL is the master when this one
is enabled. (If the role is master, the ZyWALL preempts by default.)
Click Advanced to display more settings. Click Basic to display fewer settings.
Type the cluster ID number. A virtual router consists of a master ZyWALL and all of
its backup ZyWALLs. If you have multiple ZyWALL virtual routers on your network,
use a different cluster ID for each virtual router.
Section 35.4 on page 592
ZyWALL USG 100/200 Series User's Guide
for more