Configuring Static Route For Routing To Another Network - ZyXEL Communications VMG1312-B10B Series User Manual

4.5 Configuring Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to
the Device's LAN. The router may be used to separate two department networks. This tutorial
shows how to configure a static routing rule for two network routings.
In the following figure, router R is connected to the Device's LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1
network) to computer B (in N2 network), the traffic is sent to the Device's WAN default gateway by
default. In this case, B will never receive the traffic.
N1
You need to specify a static routing rule on the Device to specify R as the router in charge of
forwarding traffic to N2. In this case, the Device routes traffic from A to R and then R routes the
traffic to B.
N1
VMG1312-B10B / VMG1312-B30B Series User's Guide
A
A
R
N2
B
R
N2
B
Chapter 4 Tutorials
47