Table of Contents
Advertisement
CPU—Based on Motorola's MPC 8245.
l
FLASH—Contains 8 MB of FLASH Memory.
l
SDRAM—Contains 32 MB.
l
PowerConnect 3324 Front Panel
PowerConnect 3348 Front Panel
Mode Button
The Mode Button toggles between port activity and port duplex settings.
Stack ID Button
The PowerConnect 3324/3348 front panel contains a Stack ID button that permits network administrators to manually select the Stack Master and stack
members.
NOTE:
The Stack Master and stack members must be selected within 15 seconds after booting the device. If the Stack Master is not selected within 15
seconds, the device must be reset to select the Unit IDs.
Once the Stack Master is selected, the remaining devices are defined as stack members. Master units receive the Unit ID of 1. Stack members receive a
separate Unit ID (2-6). For example, if there are 4 units in a stack, the Master unit is 1, the second stack member is 2, the third stack member is 3, and the
fourth stack member is 4.
Stacking Modules and Connectors
PowerConnect 3324/3348 Stacking modules are connected to port G2. The Stack module is a mini GBIC module with two stacking connectors: RX and TX. RX is
the lower connection point, and TX is the upper connection point. The module is connected to other stacking units using a stacking cable connection. The top
unit's RX is connected to the lower unit's TX. This completes the Ring Topology. The Stacking Connections figure illustrates the Ring Topology.
Advertisement
Table of Contents
