Table of Contents
Advertisement
console(config-if)# end
The following message displays:
console# sh interfaces status port-channel 1
Flow Link Back
ch Type Duplex Speed Neg Control State Pressure
..............................................................
ch1 100M Full 100 Disabled Off Up Disabled
The following table summarizes the equivalent CLI commands for configuring LAGs as displayed in the LAG Configuration page.
CLI Command
interface port-channel port-channel-number
channel-group port-channel-number mode {on
| auto}
show interfaces port-channel [port-channel-
number]
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e5
Console (config-if)# channel-group 1 mode on
Console (config-if)# exit
Console (config-if)# exit
Console # show interfaces port-channel
Channel Port
------------ ----------------------------------
1 Active 1/e5, 2/e2 Inactive 3/e3
2 Active 1/e2
3 Inactive 3/e8
Description
Creates a port-channel and enters port-channel configuration mode.
Associates a port with a port-channel.
Displays Port-channel information (which ports are members of a Port-channel, and whether they are
currently active or not).
Advertisement
Table of Contents
